The effect of feed rate on durability and wear of exchangeable cutting inserts during cutting Ni-625

Autor: Petrú, Jana, Zlámal, Tomáš, Čep, Robert, Sadílek, Marek, Stančeková, Dana
Matična publikacija: Tehnički vjesnik (Strojarski fakultet) (2017)

Influence of cutting parameters on heat-affected zone after laser cutting

Autor: Petrú, Jana
Matična publikacija: Tehnički vjesnik (Strojarski fakultet) (2013)

Testing ceramics inserts at irregular interrupted cut on material 14MoV6

Autor: Čep, Robert, Kyncl, Ladislav, Malotová, Šárka, Petrú, Jana, Zlámal, Tomáš, Czan, Andrej
Matična publikacija: Engineering review (Technical Faculty University of Rijeka) (2017)

Cutting tool wear monitoring with the use of impedance layers

Autor: Sadílek, Marek
Matična publikacija: Tehnički vjesnik (Strojarski fakultet) (2014)

Influence of focusing tube wear on vibrations and surface roughness

Autor: Radvanska, Agata
Matična publikacija: Tehnički vjesnik (Strojarski fakultet) (2015)

Rationalization of manufacturing of plastic injection moulds by abrasive waterjet

Autor: Radvanska, Agata
Matična publikacija: Tehnički vjesnik (Strojarski fakultet) (2015)

Evaluation of residual stresses after irregular interrupted machining

Autor: Malotová, Šárka, Čep, Robert, Zlámal, Tomáš, Mohyla, Petr, Czan, Andrej, Antić, Aleksandar, inženjer građevinarstva, Budak, Igor, Mircea, Lobonţiu
Matična publikacija: Tehnički vjesnik (Strojarski fakultet) (2018)